Annular cutters: HSS vs carbide, cutting depths and sizes

Annular cutters bore clean holes in steel with a magnetic drill. We carry CS Unitec and Drill America HSS and carbide-tipped cutters in inch and metric sizes. Shop annular cutters.

What is an annular cutter?

A hollow, ring-shaped cutter used in a magnetic drill to bore holes in steel. It cuts only the outer ring of the hole and leaves a solid center piece (the slug), so it removes less metal than a twist drill and usually cuts a larger hole faster. They are also called core drills, broach cutters or slugger bits.

HSS or carbide-tipped: which do I need?

  • High-speed steel (HSS): the everyday choice for mild steel and general fabrication.
  • Carbide-tipped: for harder, tougher or abrasive steel, stainless, and longer production runs.

For example: 4-3/8 x 2 in. HSS cutter or 1/2 x 1 in. carbide-tipped cutter.

Which cutting depth should I choose?

Pick a depth at least as deep as the material you are cutting through. Cutters here come in 1 in., 2 in. and 3 in. depths (and metric depths such as 25 mm). Shorter cutters are stiffer; longer ones reach through thicker plate or stacked parts. The depth is the second number in the title: 1/2 x 1 in. means a 1/2 in. hole, 1 in. deep.

Do I need a pilot pin?

Yes, in most setups. The pilot pin centers the cutter on your mark and pushes the slug out when the cut is done. Pick the pin that matches the cutter series and depth. See a pilot pin example.

Will these fit my magnetic drill?

Check the shank. Many cutters here have a Nitto/Weldon shank, and each title names the shank and part number. If you're not sure, send your list with your drill model and we'll check it.

Need a hole saw instead? See hole saws and hole cutters.